Page 1 of 1
TM1 Architect not showing any servers after installation
Posted: Sun Nov 11, 2018 10:59 pm
by tm1ic5
I just did a fresh install on my Windows 2016 server. I have multiple sample servers and a server I created running currently (verified through Cognos Configuration and Services).
When I go to the gateway URI or open TM1 architect none of the servers show up. Any ideas why?
Re: TM1 Architect not showing any servers after installation
Posted: Mon Nov 12, 2018 8:34 am
by orlando
Hi,
you didn't worte which version.
So, my first guess is: old 10.xxx version with expired certificates
http://www-01.ibm.com/support/docview.w ... SS9RXT-_-R
best regards
orlando
Re: TM1 Architect not showing any servers after installation
Posted: Mon Nov 12, 2018 3:06 pm
by tm1ic5
I am using 10.2.2 version .
Re: TM1 Architect not showing any servers after installation
Posted: Mon Nov 12, 2018 3:07 pm
by tm1ic5
I am using 10.2.2 version .
Re: TM1 Architect not showing any servers after installation
Posted: Mon Nov 12, 2018 3:23 pm
by orlando
tm1ic5 wrote: ↑Mon Nov 12, 2018 3:07 pm
I am using 10.2.2 version .
Also the 10.2.2 expired
http://www-01.ibm.com/support/docview.w ... wg21993451
Re: TM1 Architect not showing any servers after installation
Posted: Tue Nov 13, 2018 8:35 pm
by mvaspal
10.2.2 FP7 is the first release with the new certs