Page 1 of 1

TM1 DISPLAYS #N/A VALUES INSTEAD OF "0"

Posted: Thu Nov 01, 2018 5:38 pm
by mce
Hi,

In Planning Analytics Local v2.0.5 environment, I created a cube with 27 dimensions and it displays #N/A as value in consolidated cells although there is no rule in the cube at all.
Did you face this issue before? Any comments will be appreciated.

Regards,

Re: TM1 DISPLAYS #N/A VALUES INSTEAD OF "0"

Posted: Thu Nov 01, 2018 5:59 pm
by mce
Restarting Architect solves the issue.

Re: TM1 DISPLAYS #N/A VALUES INSTEAD OF "0"

Posted: Fri Nov 02, 2018 8:16 am
by Steve Rowe
27 dimensions !
Are you sure?

Re: TM1 DISPLAYS #N/A VALUES INSTEAD OF "0"

Posted: Mon Nov 12, 2018 10:41 am
by mvaspal
Restarting Architect solves the issue.
That can be the case when you are stuck in batch update mode, for example a TI that you run switches it on on the Prolog but then aborts without switching it off on the epilog