TM1 Forum

Hi All,

I have upgraded tm1 version 10.2.2 to PA 2.0.3. But there is one critical report view slowed down, where in the condition before the upgrade is 15-20 seconds and after the upgrade to 25-30 seconds. is there any cause that makes a performance difference? is there a custom configuration that needs to be set in PA 2.0.3 ?

Thanks.

Do you probably need adjustments on VMM and VMT in the }CubeProperties Cube?

Could you expand on what kind of adjustments might be needed?

I think this Blog-Post explains the use of this 2 entries much better than I can. So probably the upgrade gets the used cube a bit over the threshhold.